For EPEVER regulator, It is best to set mode USER with the following parameters:
- Absorption (Boost/bulk charge): 14,2v (in batteries flying fish white sticker13.8v)
- Absorption time (Boost Time): 90 minutes
- Equalization (Equal. charge): 14.2v
- equalization time (Equalize time): 0 Minutes
- Floatation (Float charge): 13,8v
- Absorption reconnection voltage (Boost/bulk recovery voltaje): 13.4v
- Li-ion battery protect: Enable (only from the app)
And if it is done from the mobile application.. dentro de Battery parameter settings
- Li-batt low temperature charging limit: 0.00º
- Li-batt low temperature discharging limit: -10.00º
*The rest of the parameters remain as they are!!
To be able to put that configuration in the epever, it will be necessary to have the wifi or bluetooth module, or failing that, the MT50 screen or the connection cable to the computer.
This configuration is applicable to any other solar regulator, Whatever brand it is as long as you have the option. “user” of not having it, the best configuration is usually mode “GEL”
If at the end of the day you do not end the battery to 100% And you can't stand to see it below.. There is only one option, and is to put flotation and absorption at 14.2v, it's not “bueno” Force cells daily to that voltage, Although it is less than the original charger at 14.6v. So if you want the plates to keep the 100% Until last hour.. Do that knowing that in the long term “can” That affects and decreases the total battery cycles, You do it under your “responsibility”.
