【 Cyrix-ct 120a automatic relay 】Victron Energy battery separator

RELE AUTOMÁTICO VICTRON ENERGY Cyrix-Li-ct 120A 12v-24v

Alternativa is, Better battery control to avoid unwanted switches

They have many names, battery combinators, voltage controlled relays, the divided load.

To load your secondary battery when the engine is running, This model is double meaning, So if you have solar panels once your service or stationary battery is loaded, will start loading the motor battery.

Long screws for firm connection
Cyrix 12/24-120: 13 mm (M6)
Cyrix 12/24-230: 16 mm (M8)

Intelligent overheating protection (motor start)

In case of spoiling the main battery, Through the ASYST button we can connect the relay to start with the secondary battery.

In case of repeated attempts the release could be overheated, Cyrix will be deactivated in case of excessive temperature, And it will be activated again once it has cooled.

STATE INDICATOR LED (Only Cyrix 12/24 230)
LED ignition: activated
LED flash 10 s: disabled
LED flash 2 s: connecting
LED flicker 2 s: disconnecting
LED flicker 0,25 s: alarm (overheating; strain > 16 V; Both batteries < 10 V; A battery < 2 V)
(multiply by 24 V)

12/24V Self -regulated
This relay model can function indistinctly at 12V and 24V. Cyrix-CT automatically detects the operating voltage and adjusts.

Without tension loss
Unlike battery separators with diodes bridge El Cyrix It does not have tension fall. It is an excellent substitute and much more efficient.

Start battery priority
In a normal disposition, The alternator connects directly to the start battery. The service battery, And maybe
Also the proper propeller, and other batteries are connected, each one, on the start battery with Cyrix combinators.
When the Cyrix detects that the starting battery has reached the connection voltage, will be activated to allow
parallel load of the other batteries.

Tension sensor and bidirectional food of both batteries
Cyrix detects the tension of both connected batteries. Therefore, It will also be activated if, For example, The battery of
service is being charged by a battery charger.
El Cyrix-ct 12/24 It has dual food. Therefore, It will also disconnect if the battery voltage is
Too low to run the Cyrix.
To prevent it from working unexpectedly during installation, or when a battery is disconnected, the cyrix-i 12/24-100 no
It will close if the tension of one of the two connected batteries is below 2 V (battery 12 V) or of 4 V (battery
24 V).

Parallel connection in case of emergency (StartAssist)
Cyrix can also be activated by a button (Cyrix remains connected during 30 s) or through a
Switch to connect batteries in parallel manually.
This is especially useful in case of emergency, When the starter battery is downloaded or damaged.